Diy guide: conquer the ge water heater pilot light with these quick tips
What To Know
- If you’re facing a cold shower or a lukewarm bath, it might be time to reignite the pilot light on your GE water heater.
- By following these steps, you can successfully turn on the pilot light on your GE water heater and enjoy a warm shower or bath once again.
- If the pilot light won‘t stay lit, or if you notice a yellow or orange flame instead of a blue flame, it may indicate a problem.
If you’re facing a cold shower or a lukewarm bath, it might be time to reignite the pilot light on your GE water heater. Don’t worry; this simple task can be easily accomplished with the right instructions. Here’s a step-by-step guide to illuminate your water heater and restore hot water to your home.
Safety First
Before you begin, ensure your safety by following these precautions:
- Turn off the gas supply to the water heater.
- Ventilate the area by opening windows or doors.
- Have a working fire extinguisher nearby.
Gather Your Tools
You’ll need the following tools for this task:
- Long-neck lighter or match
- Screwdriver (optional)
Locating the Pilot Light
- Locate the access panel on the bottom or side of the water heater.
- Inside the panel, you’ll find the pilot light assembly. It’s usually a small, brass tube with a flame burning at the end.
Step 1: Shut Off Gas Supply
- Turn the gas control valve to the “OFF” position. This valve is typically located near the gas supply line.
Step 2: Wait for Gas to Dissipate
- Leave the gas supply off for at least 5 minutes to allow any remaining gas to escape.
Step 3: Open Access Panel
- Remove the access panel to expose the pilot light assembly.
Step 4: Press Pilot Light Button
- Locate the pilot light button on the assembly. It’s usually a small, red button.
- Press and hold the button for 30-60 seconds.
Step 5: Light the Pilot Light
- While holding the button, use a long-neck lighter or match to ignite the pilot light.
- Hold the flame near the burner until the pilot light stays lit on its own.
Step 6: Release Pilot Light Button
- Once the pilot light is burning, release the button.
Step 7: Adjust Flame Height
- If the flame is too low, use a screwdriver to adjust the flame height control screw. Turning the screw clockwise increases the flame height.
Step 8: Reassemble Access Panel
- Replace the access panel and secure it tightly.
Step 9: Turn On Gas Supply
- Slowly turn the gas control valve to the “ON” position.
- Check for any gas leaks by listening for hissing sounds or using a soapy water solution around the gas connections.
Troubleshooting
- No flame: Ensure the gas supply is on, the pilot light button is pressed, and the flame is ignited properly.
- Low flame: Adjust the flame height control screw clockwise.
- Gas leak: Call a licensed plumber immediately.
Conclusion: Restoring Warmth and Comfort
By following these steps, you can successfully turn on the pilot light on your GE water heater and enjoy a warm shower or bath once again. Remember to prioritize safety throughout the process and seek professional help if you encounter any difficulties.
FAQs
Q: How often should I light the pilot light on my water heater?
A: Typically, you should only need to light the pilot light if it has been extinguished.
Q: What are the signs of a faulty pilot light?
A: If the pilot light won‘t stay lit, or if you notice a yellow or orange flame instead of a blue flame, it may indicate a problem.
Q: Can I turn on the water heater without the pilot light?
A: No, the pilot light is essential for igniting the burner that heats the water.