Diy shower makeover: learn how to switch your delta shower valve in minutes
What To Know
- Use a screwdriver to loosen the screw holding the handle in place.
- Slide the new valve into the hole in the wall and tighten the large nut using an adjustable wrench.
- Revel in the satisfaction of a job well done and the newfound control over your showering experience.
Are you experiencing an unruly shower that refuses to cooperate with your temperature demands? If so, it’s time to embark on the journey of changing your shower valve delta. This comprehensive guide will empower you with the knowledge and confidence to tackle this plumbing project like a pro.
Tools and Materials You’ll Need
Before diving into the process, gather the following tools and materials:
- Adjustable wrench
- Screwdriver
- Pliers
- New Delta shower valve
- Teflon tape
- Plumber’s putty
- Utility knife
- Safety glasses
Safety First
Remember to prioritize safety throughout this project. Wear safety glasses to protect your eyes from flying debris. Ensure the water supply is turned off before starting any work.
Step 1: Remove the Handle
Start by removing the decorative cap on the shower handle. Use a screwdriver to loosen the screw holding the handle in place. Once the screw is removed, gently pull the handle away from the valve body.
Step 2: Remove the Trim Plate
Behind the handle, you’ll find a trim plate secured with screws. Remove these screws and carefully lift the trim plate away from the wall. This will expose the valve body.
Step 3: Disconnect the Water Lines
Locate the two water lines connected to the valve body. Use an adjustable wrench to disconnect these lines. Be prepared for some water to leak out.
Step 4: Remove the Old Valve
Use an adjustable wrench to loosen the large nut holding the old valve in place. Once loose, carefully pull the old valve out of the wall.
Step 5: Install the New Valve
Apply a layer of Teflon tape to the threads of the new valve. Slide the new valve into the hole in the wall and tighten the large nut using an adjustable wrench.
Step 6: Reconnect the Water Lines
Reattach the water lines to the new valve by hand-tightening them first. Use an adjustable wrench to further tighten the connections.
Step 7: Install the Trim Plate and Handle
Slide the trim plate back into place and secure it with the screws you removed earlier. Install the handle and tighten the screw. Replace the decorative cap.
Troubleshooting Common Issues
Leaking from the Handle
- Check if the handle is properly tightened.
- Replace the O-rings inside the handle.
Water Not Mixing Properly
- Ensure the hot and cold water lines are connected correctly.
- Replace the cartridge inside the valve.
Low Water Pressure
- Clean the aerator on the showerhead.
- Check if the valve is fully open.
Wrap-Up: A Renewed Shower Experience
Congratulations! You’ve successfully changed your shower valve delta. Now, you can enjoy a perfectly functioning shower that delivers the perfect temperature every time. Revel in the satisfaction of a job well done and the newfound control over your showering experience.
Popular Questions
Q: How often should I change my shower valve delta?
A: It depends on the usage and wear and tear. Generally, it’s recommended to change it every 5-10 years.
Q: Can I change the valve myself if I’m not a plumber?
A: Yes, it’s possible with the right tools and instructions. However, if you’re not confident, it’s advisable to seek professional help.
Q: What type of shower valve delta should I use?
A: Choose a valve that is compatible with your shower system and meets your flow rate and temperature requirements.