Get The Perfect Fit: How To Move Your Toilet Flange 2 Inches Or More!
What To Know
- Moving a toilet flange 2 inches may seem like an intimidating task, but with the right guidance, it becomes a manageable endeavor.
- Use a toilet flange extender of the appropriate thickness to achieve the desired offset.
- The cost of moving a toilet flange can vary depending on the complexity of the project and the materials used.
Moving a toilet flange 2 inches may seem like an intimidating task, but with the right guidance, it becomes a manageable endeavor. In this comprehensive guide, we’ll delve into the intricacies of toilet flange relocation, providing step-by-step instructions and expert tips to ensure a successful outcome.
Tools and Materials
Before embarking on this project, gather the necessary tools and materials:
- Toilet flange extender
- Hacksaw
- Measuring tape
- Level
- Pencil
- Pry bar
- New bolts and washers
- Plumber’s putty
- Sealant
Prerequisites: Safety First
- Shut off the water supply to the toilet.
- Flush the toilet to remove any remaining water.
- Disconnect the water supply line from the toilet.
Step 1: Remove the Toilet
- Carefully lift the toilet straight up and off the flange.
- Set the toilet aside in a safe location.
Step 2: Remove the Old Flange
- Use a hacksaw to cut the old flange flush with the floor.
- Pry up the old flange using a pry bar.
- Clean the area where the old flange was located.
Step 3: Install the Toilet Flange Extender
- Measure and mark the desired location of the new flange.
- Apply a bead of plumber’s putty to the base of the flange extender.
- Position the flange extender over the marked location and press it firmly into place.
- Level the flange extender using a level.
Step 4: Install the New Flange
- Place the new flange over the flange extender.
- Secure the flange with bolts and washers.
- Tighten the bolts securely.
Step 5: Seal Around the Flange
- Apply a generous bead of sealant around the base of the flange.
- Smooth out the sealant using your finger or a putty knife.
Step 6: Reinstall the Toilet
- Reposition the toilet over the new flange.
- Gently lower the toilet until it rests on the flange.
- Reconnect the water supply line to the toilet.
Step 7: Finalize the Installation
- Turn on the water supply and check for leaks.
- Flush the toilet to ensure proper drainage.
Tips for Success
- Use a toilet flange extender of the appropriate thickness to achieve the desired offset.
- Position the new flange carefully to avoid any misalignment issues.
- Tighten the bolts securely to prevent the flange from moving.
- Seal around the flange thoroughly to prevent water leaks.
- If you encounter any difficulties, consult a licensed plumber.
Troubleshooting: Common Problems
- Toilet wobbles after installation: Check if the flange is properly secured and level.
- Water leaks around the flange: Ensure that the flange is sealed properly and that the bolts are tight.
- Toilet does not flush properly: Check if the flange is positioned too high or too low, affecting the drainage.
Answers to Your Questions
Q: Can I move a toilet flange myself?
A: Yes, it is possible to move a toilet flange yourself with the proper tools and knowledge.
Q: How much does it cost to move a toilet flange?
A: The cost of moving a toilet flange can vary depending on the complexity of the project and the materials used. It typically ranges from $50 to $200.
Q: What is the best way to seal around a toilet flange?
A: Use a high-quality silicone sealant and apply it generously around the base of the flange.
